Tool Specifications; Machine Elements; Noise/Vibration Information - Bosch GKS 55 PROFESSIONAL Instructions D'emploi

1 609 929 F95.book Seite 1 Montag, 11. Oktober 2004 11:58 11

Tool Specifications

Circular Saw
Article number
Rated input power [W]
No-load speed [rpm] 5 200
Speed under load,
max. [rpm] 3 800
Cutting depth
at 90°, max. [mm] 55
Cutting depth
at 45°, max. [mm] 38.5
Spindle lock
Base plate [mm] 145 x 290
Weight according
to EPTA-Procedure
01/2003 [kg]
Protection class
Saw blade dia. (max.) [mm] 160
Saw blade dia. (min) [mm] 150
Blade thickness,
max. [mm] 1.7
Teeth thickness/
teeth setting, max. [mm] 2.6
Teeth thickness/
teeth setting, min. [mm] 1.8
Mounting hole [mm] 20
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltages and models for specific
countries, these values can vary.

Noise/Vibration Information

Measured values determined according to
EN 60 745.
Typically the A-weighted noise levels of the ma-
chine are: sound pressure level 96 dB (A); sound
power level 107 dB (A).
uncertainty K = 3 dB.
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
13 • 1 609 929 F95 • 04.11

Machine Elements

The numbering of the machine elements refers to
GKS 55
the illustration of the machine on the graphics
PROFESSIONAL
page.
3 601 F64 0..
While reading the operating instructions, unfold
1 200
the graphics page for the machine and leave it
open.
1 On/Off switch
2 Lock-off button
3 Auxiliary handle
4 Spindle lock button
5 Cutting angle scale
6 Allen key
7 Winged screw for cutting angle setting
8 Winged screw for parallel guide
3.5
9 Cutting mark, 45°
/ II
10 Cutting mark, 0°
11 Parallel guide
12 Retracting blade guard
13 Adjustment lever for retracting blade guard
14 Base plate
15 Winged screw for cutting angle pre-selection
16 Sawdust ejector
17 Blade guard
18 Drive spindle
19 Mounting flange
20 Circular saw blade*
21 Clamping flange
22 Clamping bolt with washer
23 Clamping lever for cutting depth preselection
24 Cutting depth scale
25 Extraction adapter*
26 Set of screw clamps*
27 Guide rail*
28 Connection piece*
Measurement
29 Vacuum hose*
30 Guide-rail adapter*
2
.
* Not all of the accessories illustrated or described are
included as standard delivery.
English - 1