Senco FUSION F-LXP Mode D'emploi page 18

EN
Problem/Symptom
Poor feed/ tool jamming.
Broken or worn driver.
Tool does not fully return.
Ensuring the long life of your Cordless Finish tool
Welcome to SENCO's family of products. SENCO brings 50 years of commitment to our customers and to power fastening systems. We are
dedicated to making sure your tools are performing at their best, and we understand that ensuring the long life of your tools is important. Here
are some operational and service tips.
• Start with fully charged batteries at the beginning of each work day.
• Set the depth of drive on your SENCO tool so fasteners are not over-driven.
• To maximize battery life, follow storage recommendations and charging recommendations in this manual.
• Keep your Cordless Nailer as clean and free of debris as possible.
• Service your SENCO tool periodically to insure your tool is productive and helping you earn money on the job. See the service guide
below for recommended service intervals.
If your Cordless Nailer does require service, dedicated SENCO servicing dealers are available for you. For the location nearest you visit SENCO's
website (www.senco.eu).
Recommended service includes
• Check Electrical System
• Check Feed System
• Check Drive Track
• Add Grease to Piston and Driver
TROUBLESHOOTING
Probable Cause
Debris build-up in mechanism.
Driver tip not located above fastener.
Weak battery.
18
Corrective Action
Clean tool, clean magazine or inspect feeder
spring.
Return tool to authorized SENCO service
representative.
Recharge battery and allow tool to automati-
cally retract driver.