Rear Panel - Tascam US-16x08 Mode D'emploi

USB indicator
8
This lights orange when the USB connection is working.
CAUTION
Before connecting headphones, minimize the volume with
the PHONES knob. Failure to do so might cause sudden loud
noises, which could harm your hearing or result in other
trouble.

Rear panel

USB port
9
Use the included USB cable to connect the unit to a
computer or an iOS device. (Supports USB 2.0.)
MIDI OUT connector
0
This 5-pin DIN is a standard MIDI output connector.
This outputs MIDI signals.
MIDI IN connector
q
This 5-pin DIN is a standard MIDI input connector.
Use this to input MIDI signals.
LINE IN11-16 (BALANCED) jacks/LEVEL switches
w
LINE IN11-16 jacks are standard TRS line input jacks. Use the
LEVEL switches to set the nominal levels to −10 dBV or
+4 dBu.
(Tip: HOT, Ring: COLD, Sleeve: GND)
NOTE
The input gain cannot be adjusted.
Cord holder
e
Use to hook the included AC adapter cord to prevent the
plug from falling out.
6
TASCAM US-16x08
LINE OUT1-8 (BALANCED) jacks
r
These standard TRS jacks are analog line inputs. The rated
output level is +4 dBu.
(Tip: HOT, Ring: COLD, Sleeve: GND)
AUTO POWER SAVE switch
t
During Mic Preamp mode, use this switch to set whether to
automatically turn the unit off (put it in standby) when the
signal level continues to be −60 dBFS or less for 30 minutes.
CAUTION
If you want to turn the unit on again after it has turned itself
off automatically using this function, set the STANDBY/ON
switch to off once, wait at least 8 seconds, and then set the
STANDBY/ON to on again.
DC IN 12V connector
y
Connect the included DC12V AC adapter (GPE248-120200-Z)
here.