Attaching Rack Mount Angles; Connecting The Power; Changing The Outlet Plug - Tascam US-16x08 Mode D'emploi

Masquer les pouces Voir aussi pour US-16x08:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17

Attaching Rack Mount Angles

To rack mount the unit, you must replace the side frames with
the included rack mount angles. Follow the procedure below to
replace them.
(Have a Phillips screwdriver ready.)
1. Using the hex key included with the product, remove the
four screws from each side of the unit, as indicated in the
following figure.
2. Remove the frame from each side of the unit.
3. Attach the included rack mount angles to the unit using
the included rack mount angle attachment screws and the
Phillips screwdriver.
4. To reattach the original frames, reverse the above procedure.

Connecting the power

Use the included AC adapter to connect a power supply to the
unit as shown below.
• The AC adapter includes two types of outlet plugs. Attach
the type of plug that matches the power outlet that you are
using.
Power outlet
GPE248-120200-Z (included)
In order to prevent the cord from becoming disconnected
during use, wrap the cord around the cord holder.
CAUTION
Always use the dedicated AC adapter (GPE248-120200-Z,
DC12V) that was shipped with the unit. Using a different AC
adapter could cause malfunction, overheating, fire or other
problems.

Changing the outlet plug

1. Move the latch on the AC adapter in the direction of the
arrow.
2. Pull off the outlet plug.
3. Replace it with the other outlet plug (A or B).
4. Move the latch on the AC adapter in the direction of the
arrow again.
5. Attach the outlet plug to the AC adapter.
This completes changing the outlet plug.
After changing the outlet plug, confirm that it is not loose
or crooked and that everything is normal before plugging it
into an outlet.
CAUTION
Do not use the adapter if there is anything abnormal about
the plug after changing it. Use when the plug is abnormal
could cause fire or electric shock. Contact the retailer where
you purchased the unit or a TEAC service center (on the back
cover) to request repair.
DC plug
2
1
TASCAM US-16x08
3
5
4
9

Publicité

Table des Matières
loading

Table des Matières