Safety Instructions; Putting Into Operation - Trotec B 400 Notice D'emploi

Table of Contents
01. Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B - 1
02. Putting into operation . . . . . . . . . . . . . . . . . . . . . . . . . . . B - 1
03. Array. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B - 1
04. Use and care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B - 2
05. Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B - 2
The following publication replaces all previous publications. This publication may not be reproduced, even in part,
or processed using electronic means or distributed without prior written consent from us. We reserve the right to
carry out technical modifications. All brand names are used without the guarantee for their free use and written
in accordance with the manufactures' wishes. The brand names used are registered trade marks and should be
treated as such. We reserve the right to change the construction, form and colour in the interest of the ongoing
development of our products. The scope of delivery can deviate from the components displayed in the illustration.
We do not accept any responsibility for errors or omissions. © TROTEC®

01. Safety instructions

Read this guide carefully and note all recommended safety precau-
tions prior and after using this equipment. Keep your humidifier in
good working condition. Make yourself familiar with instructions and
safety guides related to the use of your unit prior to operation. Keep
this user guide for future reference.
Carton content
• Humidifier body
• Grille
• Evaporative pad holder (drum) with pads
• Water tank
• Operation instructions
Please pay attention to the following safety information:
• People who have not read this manual or are not used to this kind
of product should not be allowed to use the unit.
• Your humidifier is designed to be used with AC current. Never use
anything else than alternative current for this unit.
• Always switch off and unplug your unit when not in operation.
• For more safety, it is recommended to include in the installa-
tion a high sensitivity default circuit breaker (30 mA). If you do not
know the specifications of your installation, please ask a qualified
electrician. If you do not have a high sensitivity circuit breaker, we
recommend to have one installed.
• Before using the humidifier, make sure that it is NOT in the "ON"
position and all assembly and installation procedures have been
followed.
• Connect the supply cord to an electrical wall socket with ground.
Do not use a non-earthed supply like an extension cord, a light
bulb socket or others.
• Place on/off switch to off position and disconnect from wall socket
prior to refilling the unit.
• If the supply cord is damaged, it must be replaced by the manu-
facturer or its service agent or similar qualified person in order to
avoid a hazard.

02. Putting into operation

Read all instructions before using this new appliance:
• Unpack unit from packing.
• Completely unravel power cord. Do not damage it.
B - 1
• Remove adhesive tape from top cover.
• Remove wedge which holds circular foam holder, then remove
holder from humidifier taking hold of its axis.
• Place drum inside humidifier.
• Pull slightly outward water tank.
• Place water reservoir in its initial setting.
03. Array
For best results we recommend you to locate your unit in the middle
of premises. If room is heated by pulsed air please set unit near
source of pulsed air.
Do not place humidifier near furniture, paintings or any other object
which humidity could damage.
CONNECTING TO MAINS
• Before using the humidifier, extend the cord and inspect for any
signs of damage, inspect plug and socket. You should use earth
socket.
• Connect the unit to mains (230 Volt - 50 Hz 10 Amps). Humidifier
consumption does not exceed 0,5 Amps (110Wh).
FILLING UP HUMIDIFIER
• Make sure the humidifier is switched OFF.
• Unplug unit from mains.
• Flip open filling cover.
• Be very careful while filling up reservoir, do not spill water on unit
controls, or on inside sides of unit. STOP filling 2 cm under water
level indicated.
• Wipe dry any spilled water from control panel. Make sure unit is
quite dry before proceeding.
• Connect humidifier to mains.
HOW TO USE YOUR HUMIDIFIER
Please become familiar with the various commands of your humi-
difier:
• To turn off unit, switch it "OFF". To turn it on, switch it to the "ON"
position. There are 2 speeds (speed 1, speed 2) to choose from.
• The humidistat (% humidity) allows you to regulate the humidity
level in the premises. If your turn backward the humidistat it will
stop the unit. On the contrary if you turn it to its maximum, the unit
will run continuously.
• The reservoir float will stop the humidifier when the amount of
water is below 2 cm.
• The warning lights (WATER), (% HUMIDITY) and (ON) indicate at all
times if the unit is in good working order.
When the red warning light (WATER) is "ON", the reservoir water
level is insufficient. See filling up procedure.
When the orange warning light is ON (% HUMIDITY), the room humi-
dity level is either the same or higher than the humidistat setting. If
a higher level of humidity is required, turn the humidistat clock wise
to the required level. The green warning light comes "ON" when the
fan is operating, this also means the water level in the reservoir is
sufficient and the humidistat setting level is higher than the room
relative humidity level (%humidity).
Operating Instructions – Humidifier B 400