HOMCOM TST10-RD Mode D'emploi page 3

•
Cleaning and maintenance of the product must not be performed by children.
•
Children do not recognize the hazards which can arise when handling electrical
devices. Keep children away from the device. Pay particular attention when using
the device if children are in the vicinity!
•
Keep the packaging materials such as plastic bags and polystyrene parts out of
the reach of children. Danger of suffocation!
•
When laying the cable make sure that it cannot become a tripping hazard.
•
Make sure that the device itself cannot be tripped over.
ARTICLE-SPECIFIC HAZARDS
• Make sure that the device isn't dirty and that it is assembled correctly
• Never operate the appliance on uneven surfaces or in the vicinity of steps.
Avoid tipping the device over when it is in use (e.g. if there are borders on the floor).
• The pedestal fan may only be used, if it is fully assembled. Check all screw /
plug connections at regular intervals. Re-tighten loose screws and ensure that plug
connections are properly adjusted.
1. B od y
2. H o l de r
3. Timer
4. Speed
5. Mode
6. Oscillation
7. ON/OFF
8. Power plug
9. Stand
10. Screws
11. Remote control
ASSEMBLING THE STAND
1. Take all of the appliance parts out of the packaging and remove all packaging
materials and inserts.
2. Turn the fan upside down so that you can look at the holder (2). (Fig.1).
3. Connect the stand (9), part.1 and part.2. (Fig.2)
4. Take the power cord to cross the outlet hole of stand (9). (Fig.3)
5. Assembly stand (9) under the holder (2), and fixed it by screws (10). (Fig.4)
2