End Of Use; Switching Off; Maintenance - Imetec S3901 Instructions D'utilisation

END OF USE

SWITCHING OFF

EN
Remove the plug (1) from the mains socket.
Wait for the product to cool completely before putting it away.
WARNING! Risk of fire. Wait for the appliance to cool
completely before storing it.
When you have finished ironing, empty the tank to avoid water stagnation and the formation of impurities
and bacteria.
To drain the tank:
Remove the tank using the relative handle on the base.
Drain off all the water in the tank.
Reconnect the tank to the appliance base.

MAINTENANCE

Respect the safety warnings when following the procedure below.
CALC CLEAN SYSTEM - Scale removal function.
Remove the limescale every time the Calc clean indicator light button (5) starts
flashing.
Make sure there is water in the tank, and that the temperature knob is set to the
CALC CLEAN /MAX position.
Position the iron above a container and press the CALC CLEAN indicator light
button for about 10 seconds
The red indicator light will remain fixed and the iron will begin the cleaning phase
(which lasts about 2 minutes). During this time, water, steam and scale particles
will emerge from the plate.
Do not move the iron until the cleaning process has ended.
When the acoustic signal and the indicator light go off, this means the cleaning
process has been completed. Before starting to iron again, wipe the plate with a
cotton cloth to remove any residue.
The CALC CLEAN function can, in any case, be activated at any time as needed.
Just press the Clean button for 10 seconds, always making sure there is a container underneath the iron
to collect the water.
19