Télécharger Imprimer la page
OGRESS
LIGHTING
WARNING - If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full
compliance With N E.C. requirements.
WARNING
- TO
COMPLY
REQUIREMENTS,
WHEN
COMING
IN CONTACT
WITH THE MOUNTING
CAULKING
TO
PREVENT
CAUTION - All glass ISfragile, use care when handling Glass Shade and lamps
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and lor
other reproductive harm
Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product
5
6
1
I
Fasten Mounting
Plate (2) to Outlet Box (I) With Mounting Screws (3) from Outlet Box (I)
Thread Machine Screws (4) Into Mounting Plate (2)
2.- Connect Supply Wires (6) to Fixture Wires (5) as shown on Wiring Dagram
3.- Slip Fixture Housing (7) over Machine Screws (4) and secure with Capnuts (8). (SEE WARNING
4.- Attach Fixture Cage (9) to Fixture Housing (7) by squeezing Fixture Cage (9) as shown.
Position Holes (12) on sides of Fixture Cage (9) over corresponding
of Fixture Housing (7). Release Fixture Cage (9) - Pins (11) will snap into position
5.- Before snapping
Fixture Housing (7) shut install Plastic Panels (10) (TEXTURED
6.- Rotate free end of Fixture Cage (9) up to the Fixture Housing (7) and snap Into place
7.- Install lamp (NOT FURNISHED)
WARNING
• FIRE
HAZZARD:
Assembly
CAUTION:
Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation
If there are any questions, contact a Qualified Electrical Contractor.
WITH
THE
NATIONAL
ELECTRICAL
INSTALLED
OUTDOORS,
SURFACE,
WATER
FROM
ENTERING
7
3
8
4
2
11
DO NOT ALLOW
LAMP TO TOUCH
IF LAMP APPEARS
TO COME IN CONTACT
ADJUST
SOCKET
TO MOVE
LAMP
& Installation
5818
CODE
AND
UNDERWRITERS
OR IN WET LOCATIONS,
MUST BE SEALED
THE
OUTLET
BOX
7
9
7
12
9
Pins (I I) on underside
SIDE OUT)
ANY PORTION
OF THIS
FIXTURE.
WITH FIXTURE INTERIOR OR PANELS,
PAGE
1 of
2
Instructions
LABORATORIES
THE EDGE OF THE WALL PLATE
WITH A LATEX WATERPROOF
IRI
Ilfiiii'i\
10
WHITE SUPPLY
WHITE OR IDENTIFIED
WIRE
FIXTURE
BLACK
SUPPLY
PLAIN
FIXTURE
BARE, OR GREEN
BARE, OR GREEN
GROUND
WIRE
FIXTURE
FROM
SUPPLY
OR
BARE, OR GREEN
GROUND
WIRE
FROM
SUPPLY
ABOVE)
SPEC
NO
WIRE
UL LISTED
WIRE NUTS
OR BLACK
WIRE
GROUND
WIRE
GREEN
GROUND
SCREW
022244
10-22-08
loading

Sommaire des Matières pour Progress Lighting 5818

  • Page 1 Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation 5818 WARNING - If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full compliance With N E.C. requirements.
  • Page 2 Instrucciones de ensamblaje e instalaciö n. Precauciö n: Lea cuidadosamente las instrucciones y desconecte la electricidad del cortacircuitos principal antes de imciar la instalaciö ADVERTENCIA - Si usa algü n dispositivo especial de control con este aparato de luz, siga las instrucciones cuidadosamente para asegurar la completa conformidad con los requisitos N.E C.