PRO-POINT 8306078 Manuel D'utilisateur page 8

v 2.4
OPERATION
WARNING! Thistool generatesconsiderabletorque when in use.Always hold the tool with
both handswhen using,and brace yourselfto resistthe torque which will be delivered to the
work piece.
Tightenthe nut as far as you can by hand before usingthe impactwrench.
Connect the wrench to the air hose.
2.
Set the reverselever to the left, so that the anvil turns clockwise (forward).
3.
Placethe socketover the fastener,grip the impactwrenchfirmlywith both handsand
4.
gently squeezethetrigger.
Turnthe air regulatorin the directionindicatedby the arrow on the regulatorto increase
5.
the power.Turnit the other directionto decreasethe power.
NOTE:If the impactwrench doesnot tightenthe fastenerto your satisfaction, d o not
raisethe air pressure on the compressor over 110 PSI.Pressures a bove 110PSIwill stripthe
workpiece and damage the tool, potentiallycausingtool failureand seriousinjury. Useother
appropriate methodsand toolsto tightenthe nut.
6. When the fastener is tightened, release the trigger and remove the tool and socket.
7. Usea mechanical t orque wrenchto checkfastenertorque.
8. To loosen, set the reverselever to the right, so that the anvil turns
counterclockwise (reverse).
8
1 in. dr Impact Wrench
Fortechnical questionscall 1-800-665-8685
8306078