Publicité
TxConfig USB Interface
Quick Guide
The TxConfig USB is the configuration interface to configure the whole
Novus Smart Transmitters family with 0 to 10 Vdc and 4 to 20 mA
outputs. By using this interface the user can either perform the
transmitter configuration without an external power supply and
connected to the current loop. This interface works together TxConfig
software.
CHARACTERISTICS
Easy to install, no special driver needed;
USB communication between the PC and the transmitter;
Configures the transmitter without external power supply, powered
by USB bus;
Electrical connections made easy;
Compatible with USB 1.1 and 2.0;
Operating system: Windows XP, Vista and 7.
ELECTRICAL INSTALLATION
Connect the interface to the transmitter as shown in the following
figures depending on the model you are configuring;
Connect the interface to a free USB port on the PC;
The TxConfig USB interface shall be automatically installed without
any external driver.
Launch the previously installed TxConfig software in order to
perform the transmitter configuration.
OPERATION
Follow the instructions from the TxConfig Software (check Help menu);
Status Led:
- Led on: means the interface was installed and is ready to be used.
- Led blinking: means the configuration data is being sent.
Warning: When performing the configuration with the
transmitter connected to the process loop, do not
connect the black and red wires to the transmitter
in order to avoid an irreversible damage to the
interface. Connect only the white and green wires as
shown in the figures above.
ELECTRICAL CONNECTIONS
TxBlock / TxIsoBlock Transmitter
1.
English
RHT / Temp Transmitter
2.
TxRail Transmitter
3.
TxIsoRail Transmitter
4.
T x C o n f i g U S B
I n t e r f a c e
Q U I C K
G U I D E
SAFETY INFORMATION
Any control system design should take into account that any part of the system
has the potential to fail. This product is not a protection or safety device and its
alarms are not intended to protect against product failures. Independent safety
devices should be always provided if personnel or property are at risk.
Product performance and specifications may be affected by its environment and
installation. It's user's responsibility to assure proper grounding, shielding, cable
routing and electrical noise filtering, in accordance with local regulations, EMC
standards and good installation practices.
SUPPORT AND MAINTENANCE
This product contains no serviceable parts inside. Contact our local distributor
in case you need authorized service. For troubleshooting, visit our FAQ at
www.novusautomation.com.
LIMITED WARRANTY AND LIMITATION OF LIABILITY
NOVUS warrants to the original purchaser that this product is free from defects
in material and workmanship under normal use and service within one (1) year
from the date of shipment from factory or from its official sales channel to the
original purchaser.
NOVUS liability under this warranty shall not in any case exceed the cost of
correcting defects in the product or of supplying replacement product as herein
provided and upon the expiration of the warranty period all such liability shall
terminate.
For complete information on warranty and liability limitations, check appropriate
section in our web site: www.novusautomation.com.
Man 5010046
Publicité
