PRO-POINT 8868176 Mode D'emploi page 6

8868176
4. Apply rosin-based
iron. When using non-rosin-based
soldering
5. Wait for the solder to cool and harden before moving the soldered
part.
6. Leave the solder on the tip before storing to prevent oxidization.
SOLDERING
1. Plug the power adapter into the soldering
power supply.
2. A version number (003) will appear in the LCD (E), then the current
temperature
button.
3. Standby (Wait), Sleep settings and CO/FO are reached by pressing
the + and
to Standby, another 2 seconds
another 2 seconds
reach switch
4. Standby has two settings:
4.1 Wait sets the time length of inactivity before the soldering
enters standby mode. The default is 180 seconds
4.2 Wait Temp sets the soldering
standby. The default wait temperature
5. Sleep indicates the amount of time that will pass before the iron will
power off entirely, allowing the temperature
temperature.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition
easier to control and will have fewer problems.
2. Inspect the tool components
damaged
parts when servicing.
3. Replace the tip by unscrewing
new tip, then tightening
damage the heating element
6
Soldering
solder to the part and melt it with the soldering
paste to the part before applying
IRON
setting. You can alter this by pressing the + or —
- button at the same
to reach Sleep Time and another 2 seconds
between co and
The default is 360 seconds.
or worn components.
the screw. Do not overtighten
Iron with LCD
solder, be sure to apply a
SETTINGS
time. Hold
to reach Standby Temperature,
FO.
iron's temperature
periodically.
Only use identical
the barrel's screw and inserting a
For technical
the solder.
iron port (F) and the
for 2 seconds
while in
is 200 oc.
to cool to room
is efficient,
Repair or replace
replacement
as this can
questions call 1-800-665-8685
VI .O
to switch
to
iron