Functions - Ikea Rakall Mode D'emploi

Functions

Fan
The fan is pre-set to ON. You can turn the fan on/off by pressing
the light button (as shown in figure below at step 2) and at the
C
same time the button as shown in figure 3.
The light will flash just once if the fan is OFF, or it will flash below
at step 3 times if the fan in ON. If the ambient temperature
exceeds 27°C, or if drops of water are present on the glass
shelves, it is essential to have the fan on to ensure the proper
preservation of the food. Deactivation of the fan allows energy
consumption to be optimised.
1 2
Stand-by
C
Press the button for 3 seconds to deactivate the appliance
(the control panel and lights remain off). Press the button again
briefly to reactivate the appliance.
Note: This operation does not disconnect the appliance from
the power supply.
Note: the ambient temperature, frequency of door opening and
position of the appliance can affect the temperature inside the
two compartments.
These factors must be taken into account when setting the
thermostat.
Installation
The appliance must be handled and installed by two or
more persons - risk of injury. Use protective gloves to unpack
and install - risk of cuts.
Installation, including water supply (if any), electrical
connections and repairs must be carried out by a qualified
technician. Do not repair or replace any part of the appliance
unless specifically stated in the user manual. Keep children
away from the installation site. After unpacking the appliance,
make sure that it has not been damaged during transport.
In the event of problems, contact the dealer or your nearest
Aftersales Service. Once installed, packaging waste (plastic,
styrofoam parts etc.) must be stored out of reach of children -
risk of suffocation. The appliance must be disconnected from
the power supply before any installation operation - risk of
electric shock. During installation, make sure the appliance
does not damage the power cable - risk of fire or electric shock.
Only activate the appliance when the installation has been
completed.
Be careful not to damage the floors (e.g. parquet) when
moving the appliance. Install the appliance on a floor or support
strong enough to take its weight and in a place suitable for
3
LED light
LEDs last longer than traditional light bulbs, improve internal
visibility and are environmentally friendly.
Contact the Service Centre if replacement is necessary.
Refrigerator compartment
Defrosting of the refrigerator compartment is completely
automatic.
The formation of water droplets on the rear internal wall of
the refrigerator compartment indicates that the automatic
defrosting is underway.
The defrost water automatically runs into a drain outlet and
then into a container from where it evaporates.
Caution! The refrigerator accessories must not be placed in a
dishwasher.
Freezer compartment
This appliance is a refrigerator with a
compartment.
Packaged frozen food can be stored for the period of time
indicated on the packaging.
Once defrosted, food must be used within 24 hours.
its size and use. Make sure the appliance is not near a heat
source and that the four feet are stable and resting on the floor,
adjusting them as required, and check that the appliance is
perfectly level using a spirit level. Wait at least two hours before
switching the appliance on, to ensure that the refrigerant circuit
is fully efficient.
WARNING: When positioning the appliance, ensure the
supply cord is not trapped or damaged.
WARNING: To avoid a hazard due to instability, positioning
or fixing of the appliance must be done in accordance with
the manufacturer instructions. It's forbidden to place the
refrigerator in such way that the metal hose of gas stove, metal
gas or water pipes, or electrical wires are in contact with the
refrigerator back wall (condenser coil).
To guarantee adequate ventilation, leave a space on both
sides and above the appliance. The distance between the rear
of the appliance and the wall behind the appliance should be 50
mm, to avoid access to hot surfaces. A reduction of this space
will increase the Energy consumption of product. Please remove
the power cord from condenser hook during installation before
connecting product to power supply.
7
star freezer