ABB RC/A 8.2 Mode D'emploi page 16

EN
Danger
2
see illustration
Before connecting the voltage to the basic room controller, all plug-in terminals must be
properly inserted.
Important information:
Only skilled electricians are authorised to install the unit. Disconnect the power to the basic room
controller unit during installation activities, especially
- when installing or deinstalling the basic room controller unit.
- before removing the plug-in terminals!
- when connecting the outputs!
Please comply with all the relevant standards, guidelines, rules and regulations when planning and
setting up electrical installations.
- Protect the unit against humidity, dirt and damage during transport, storage and operation!
- Always operate the unit within the specified technical data!
- Operate device only in basic room controller unit!
- Make sure that the unit is used only in the admissible temperature range!