ABB RC/A 8.2 Mode D'emploi page 15

Connections:
Mains supply / feed-in
KNX
Auxiliary feed-in
Cross section of connection Supply / feed-in: 0.5...4.0 mm²
Environment:
Ambient temperature
range (operation)
Design:
Type of installation
Housing, color
Dimensions (WxHxD)
Type of enclosure
Start-up
The functionality is defined by programming the basic room controller unit. Once the power supply
has been applied the functions of the device can be tested via the manual control.
A detailed description of the parameterisation and start-up process can be found in the technical
data and in the product manual of the unit. You can download these documents on the internet
under http://www.abb.de/knx
Cleaning
Soiled units can be cleaned with a dry cloth. If this is not sufficient, you can also use a cloth that is
slightly impregnated with a soap solution. Do not use corrosive agents or solvents.
Maintenance
The unit is maintenance-free. Do not carry out any repairs when the unit is damaged (e.g. during
transport, storage).
5-pin screw terminal
2-pin screw terminal
3x2-pin plug-in screw terminal
remainder: 0.2...2.5 mm² fine wire
-20° C...45° C"
Surface-mounting device, screw fastening
Plastic, gray, free from halogens
270 x 316 x 50 mm
IP 54 according to DIN 60529
EN
0.2...4.0 mm² single wire