Elcometer P30B Manuel D'utilisation page 16

14. Observations
By following the instructions set out in this manual you will ensure good spraying and quality of
finish. Should you have any doubt, please contact the Technical Service of ELCOMETER.
15. Warranty Conditions
This device has been manufactured with great precision and has been subjected to a large
number of controls before leaving the factory.
The WARRANTY is valid for 1 year, which can be extended for a further year when registered via
https://www.elcometer.com
Or insert the QR code
https://www.elcometer.com/en/extend-your-warranty-form
ELCOMETER reserves the right to make technical modifications.
16. Disposal
For complete and correct disposal of the equipment, when it has reached the end
of its useful life, it must be completely dismantled so it can be recycled, separating
the metal and plastic components.
17. Troubleshooting
ANOMALY
The fluid does not
come
out or
insufficient output
NOTE: The symbol (*) means that before starting the procedure it is necessary to release pressure (see paragraph 9.1)
EN 14
CAUSE
Lack of air supply,
or insufficient
air supply
CHECK POINT
Twisted or obstructed
air hose and couplings
The two-way air inlet
valve is closed
Air leakage at the
air inlet
Air leakage from the
paint tank set
REMEDY
Remove any restriction
to the air flow. (*)
Open the valve
Connect and tighten
the air hose properly
See troubleshooting
item 9
www.elcometer.com