Screwing; Run-On Brake; Replacement Battery; Battery Disposal - Batavia BT-CLD001 Mode D'emploi

rotation speed to remove the jammed drill
bit more easily.

SCREWING

• Set the gear switch (2) to the screw symbol.
• Before using the machine check whether
the screw bit is inserted correctly. Avoid
over-tightening, otherwise the screw head
may be damaged or stripping of the threads
may occur.
• Use the rotating direction button (11) to set
up the rotion in clockwise direction. Insert
the screw-bit into the slot in the head of the
screw. Hold the screw bit right to the head
of the screw, otherwise the screw or the
screw head may be damaged. Press the
screw bit against the screw with a constant
pressure while driving in the screw.
• To unscrew, set the rotating direction
counter clockwise. Insert the screw bit into
the slot in the head of the screw. Hold the
screw-bit right to the head of the screw,
otherwise the screw or the screw head may
be damaged. Press the screw bit against
the screw with a constant pressure while
removing the screw.

RUN-ON BRAKE

When the ON/OFF trigger (5) is released, the
chuck brakes to a stop, thus preventing the
run-on of the tool. When driving in screws,
wait until the screw is screwed in flush with
the material and then release the ON/OFF
trigger. By doing so, the head of the
screw does not penetrate into the material.

REPLACEMENT BATTERY

A suitable replacement battery for the
cordless drill can be ordered at Batavia:
Art.No. 7061288.

BATTERY DISPOSAL

1. Run motor until batteries are completely
discharged.
18
7061249 Ma # 1203-09.indd 18
TM
2. Remove the battery from the cordless
drill. Depress the battery locking clip (7)
and pull out the battery pack from the
cordless drill.
3. Wrap heavy insulating tape around
battery terminals or enclose in a sealable
plastic bag to prevent possible shorting.
4. Dispose of batteries through your local
waste removal authority.

MAINTENANCE AND CLEANING

• Remove the battery before undertaking any
cleaning or maintenance work.
• Use only a moist cloth to clean the unit. Do
not use aggressive chemicals as benzene
or thinner, which may dissolve plastic parts,
or abrasives. Always keep the ventilation
slots clean and free from obstructions.
• In the case of malfunctions of the cordless
drill and the charger, please have the units
repaired by a professional or turn to our
customer service.
09-03-12 07:42