Logitech RS50 SYSTEM/BASE Guide D'installation page 5

RACING SEAT
The RS50 System utilises T-Nuts for attachment to most sim
racing seats Included in the box are two helper tools that ensure
the T-Nuts keep their spacing You can use the tool to check
spacing on your racing seat and make sure the T-nuts are
positioned within the helper tool so they match the holes on
the racing seat's wheel plate
a Insert the T-Nuts into the helper tool in the correct position
that matches the hole spacing on your racing seat wheel plate
b Insert the helper tools into the slots on the underside of
the RS50 base
c Position the base on your racing seat's wheel plate
so that the T-Nut positions match the required holes
Insert the M6 bolts, ensuring you use the washers
NOTE: some models of racing seat may not have a pre-drilled hole pattern that matches
all four T-Nuts In those instances it is acceptable to use just two T-Nuts, but ensure that
the bolts are tightened fully so that the base does not move during use
WARNING: do not use the wheel as leverage to assist you when getting into or out
of your racing seat as this could damage your RS50 System
* Sold separately
a
c
5 ENGLISH
b