Logitech RS50 SYSTEM/BASE Guide D'installation page 4

INSTALLATION
DESK
(For RS50 System owners, or RS50 Base owners who purchase the Table Clamp separately)
a Attach each of the T-nuts to the desk mount as indicated,
ensuring that they are not fully tightened; they will need
to be loose for the next step The included washers do not
need to be used for the desk installation method
b Place the wheel base on your desk upside down and then slide
the desk mount into the slots on the bottom of the wheel base,
sliding from the back of the base (where the USB ports are
located) towards the front until it stops
c Tighten the bolts using the hex key to lock the desk mount
in place
d Place the assembled base and desk mount onto your desk,
ensuring the feet at the bottom are aligned against the edge
Insert the clamp into the hole at the front and then tighten
by adjusting the screw handle Once the clamp has come into
contact with the desk you only need between a half and one
full turn of the handle to achieve the correct level of clamping
Do not overtighten
NOTE:
• The washers are not required for the desk installation method Keep them safe in case you
ever decide to upgrade to a racing seat
• Do also be aware of the construction of your desk and its suitability for clamping a high-
torque wheel to it Some desks use a hollow-core construction, for example, where you
have a top piece of material and a bottom piece Those pieces are likely to be thin and are
unlikely to stand up to the forces applied when the wheel is clamped in place
a
c
4 ENGLISH
b
d