PRO-POINT 8604548 Mode D'emploi page 2

V4.O
3. To release the square welding
down and turn the handle
direction until it stops.
released immediately
that, please ensure it is safe to release
welding magnet and that nothing
become dangerous.
WARNING! Always turn off power
the square welding magnet
4. This square welding magnet
break-away force holding
strong in shear force
powerful of the holding
be used when attempting
pry force.
ADVANTAGES
Cost saving. Green. Requiring
and OFF, they save money and are not affected
power loss.
Enduring. It can be left ON indefinitely
2.
working times.
Ergonomics and safety.
3.
the square welding magnet are easily positioned
precisely as needed,
ON/OFF. Reduced chances of repetitive
injuries from clamping.
4. Precise positioning. Varying
actuation cycle from OFF to ON. Precise positioning
achieved through adjusting
your material.
Non-marring. Unlike traditional
5.
welding magnet will hold materials
damaging or marring
2
Magnetic Welding
magnet, push the handle
in the counterclockwise
It will be turned OFF and
upon turning the handle. Before
the square
will fall or
tools before turning
ON or OFF to avoid
is capable of exceptional
power. It is exceptionally
as well. Prying force is the least
capabilities and great care must
to use this device with
no electricity to turn
for long
Unlike standard hand clamps,
and require little effort to turn
stress and hand
hold force throughout
the hold force while
clamps, the square
at any angle
the surfaces.
and Fabrication
When attached
6.
fixture
insert
welding
This will that
the bottom
It is also an ideal tool
7.
up nuts,
off to instantly
injury.
remaining
Support
8.
square
hold when
CARE
Do not attempt
There
1. Maintain
efficient,
ON
Keep the tool handle clean, dry and free from oil/grease
2.
by
at all times.
Maintain
3.
important
Princess Auto Ltd. for replacements.
WARNING!
the tool. An improperly
to the user and/or
the
DISPOSAL
is
Recycle
moving
appropriate
without
For technical
Square
to a ferromagnetic
for permanent or semi-permanent
a non-ferromagnetic spacer
magnet and the ferromagnetic
maximum magnetic
of the housing.
for cleaning
bolts, screws, scrap metal
release the materials.
shavings and it is ready
large or awkward parts. Use one or several
welding magnets to create
working underneath
& MAINTENANCE
to disassemble
are no user serviceable
the tool with care. A tool
easier to control and will have fewer problems.
the tool's labels and name
information. If unreadable
Only qualified service
repaired
others.
a tool damaged beyond repair
facility.
questions
8604548
repetitive assembly
mounting,
between the square
metal frame.
energy is directed into
up after work. Picks
and shavings. Turn it
Wipe off any
for use again.
a powerful support
a vehicle.
or alter the magnet.
parts inside the device.
in good condition is
plates. These carry
or missing, contact
personnel should repair
tool may present a hazard
at the
call 1-800-665-8685