Control Panel - Airxcel ROUGHNECK Série Mode D'emploi Et Utilisation

Your RV air conditioner is operated totally from the control
panel located in the ceiling assembly. There are three controls
on the ceiling assembly that help you control the air
conditioner. They are as follows:
A. The Selector Switch (System Switch) -
The selector switch determines which mode of
operation the air conditioner will be in. By rotating
the selector switch, the operator can obtain any
system function desired. Figure 1 shows system
switch location and all available system functions.
The "Operation" section explains the operational
characteristics for each mode of operation (See
Figure 1).
II. CONTROL PANEL
B.
C.
FIGURE 1
3
The Thermostat (Temperature Control) -
In the cooling mode, the thermostat regulates the
"ON" and "OFF" temperature setting at which the
compressor will operate. Switching to "MAX
COOL" bypasses the thermostatic control and locks
the compressor in the cooling mode for continuous
cooling.
In the "HEAT" mode, the thermostat regulates the
"ON" and "OFF" temperature setting at which the
heating element will operate. Constant heating
operation from bypassing the thermostatic control
is not available (See Figure 1).
Louvers -
The louvers are located at both ends of the ceiling
assembly shroud and are used in directing the
discharge air from the unit (See Figure 1).