Adjusting The Rack Posts (Optional) - Dell PowerEdge 2420 Guide D'installation

Adjusting the Rack Posts (optional)

The position of the rack posts can be adjusted to accommodate systems
of various depths.
1 Open the rack doors.
2 Remove the screws from the bottom and top of the post (see Figure 1-13).
3 Move the post to the desired location inside the side of the rack,
and replace the screws in the corresponding holes.
Figure 1-13. Adjusting the Rack Posts
NOTE:
You may now install systems into the rack. Use the white numbered labels
on the front and back of the rack mounting rails to help install products in the rack.
22
Installation Guide
1 screws
3 front rack post
2 back rack post
1
2
3