Dell PowerEdge 2420 Guide D'installation page 15

3 Reverse the top hinge body.
Pull the hinge pin upward slightly so that you can access the retention
a
clip (see Figure 1-5).
Figure 1-5. Removing the Front-Door Hinges
6
5
4
1
3
5
Using the needle-nose pliers, remove the retention clip, and then slide
b
the hinge pin out of the hinge body.
Remove the hinge spring from the hinge body.
c
Place the hinge pin, retention clip, and spring in a safe location.
d
Using the 4-mm Allen wrench, remove the Allen bolts that secure
e
the hinge body to the rack, and place the bolts with the hinge pin,
retention clip, and body spring.
Rotate the hinge body 180 degrees so that the hinge-pin holes are now
f
on the right side of the hinge body (see Figure 1-6).
hinge post
bottom hinge
retention clip
1
2 top hinge body
4 hinge pin
6 body spring
Installation Guide
2
3
13