Operation - Husqvarna LE 116P Guide De Référence Rapide

2. Put the top part of the grass catcher onto the lower
part of the grass catcher. Attach the grass catcher
frame with the clips.
3. Lift the rear cover.
4. Attach the hooks on the grass catcher to the top
edge of the chassis.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To set the product in operation position
If the handle is put in transport and storage position (see
To set the product in transport position on page 18 ), do
the procedure that follows to put the handle in operation
position.
402 - 001 - 03.11.2017
To assemble the mulch kit
1. Lift up the rear cover and remove the grass catcher.
2. Put the mulch plug into the grass discharge channel.
The mulch plug of type A is for LE 116P. Type B is
for LE 116R.
3. Close the rear cover.
4. Replace the blade with the Combi blade, see
remove and replace the blade on page 16 .

Operation

1. Lift the handle until the lower handle locks into
operation position.
A B
To
11