Safety Instructions When Using Long Drill Bits; Additional Safety Instructions; Safety Instructions For Operation; Residual Risks - Meec Tools 023318 Instructions D'utilisation

2.11 Safety instructions when using
EN
long drill bits
● Do not operate at higher speed than the maximum
SV
speed rating of the bit. At higher speeds, the bit is
likely to bend if it rotates without being in contact with
a workpiece, which can result in personal injury.
NO
● Always start the operation at low speed and when the
tip of the bit comes in contact with the workpiece,
DA
increase the speed.
● Make sure the bit is in straight line with the workpiece
when you apply pressure. Do not apply too much
PL
pressure. Bits can bend and cause breakage or loss of
control which can cause injury.
DE

2.12 Additional safety instructions

● Loose workpieces must always be fastened.
FI
● Release the trigger immediately if the product
becomes blocked. Be prepared for high torque
reactions which cause kickback.
FR
● Wait until the product has come to a complete stop
before you put it down.
NL
● Hold the product correctly. When you tighten and
loosen screws be prepare for temporarily high torque
reactions.
● Use applicable detectors to find hidden pipes or
electric lines or refer to the local utility company for
aid.

2.13 Safety instructions for operation

● Do not use the product if you are tired, ill, or
intoxicated. This will decrease your vision, alertness,
coordination and judgement.
● Do not let children or persons who do not know the
product to use it.
● Do not use the product if it is damaged.
● Do not make changes to the product.
● Use the product only for its specified function.
● Wear ear protectors when impact drilling. Exposure to
noise can cause hearing loss.

2.14 Residual risks

There will always be residual risks even if you operate the
product in accordance to the instructions.
The following hazards may occur in connection with the
type and design of this power tool:
● Hearing damage if ear protection is not worn.
8
● Health injuries as a result from the effect of vibration
on the hands and arms when the product is used over
a long period of time or when it is not used and
maintained correctly.
● Cutting injuries.
● Danger due to electromagnetic field generated while
the machine is in operation. Under certain
circumstances, this field may negatively affect active
or passive medical implants.
● In order to decrease the danger of serious or fatal
injuries, it is recommended that individuals who wear
medical implants should consult their doctor and the
manufacturer of the implant before operating the
machine.
3

Assembly

3.1 To assemble the clip to the
product
Warning! Stop the product and let the moving
parts come to a complete stop before the clip is assem-
bled.
The clip can be installed on either side of the product.
Figure 2
1
Attach the clip to the slot on the battery
compartment of the product.
2
Tighten the screw.
4

Operation

Warning! If you do not obey these instructions,
there is a risk of death or injury.
4.1

To do before each operation

● Do a check of the direction of the rotation.
4.2 To install a battery to the
product
Warning! Only the correct battery must be used
with the product.
Caution! Do not use force when you connect a
battery to the product. If the battery does not move easily
into the battery port, the battery is not installed correctly.
● Push the battery into the battery holder on the product
until a click is heard.