FAAC ND2 AUTO KIT Manuel D'installation page 3

EU DECLARATION OF CONFORMITY
The Manufacturer
Company name: FAAC S.p.A. Soc. Unipersonale
Address: Via Calari, 10 - 40069 Zola Predosa BOLOGNA - ITALY
hereby declares on his sole responsibility that the following products:
Description: Automation for shutters
Models: ND2 AUTO KIT
comply with the following applicable EU legislations:
2014/30/EU
2011/65/EU
Furthermore, the following harmonised standards have been applied:
EN 61000-3-2:2014
EN 61000-3-3:2013
Bologna, Italy, 10-01-2019 CEO
A. Marcellan
ND2 AUTO KIT
DECLARATION OF INCORPORATION FOR PARTLY
COMPLETED MACHINERY
(2006/42/EC ANNEX II P.1, B)
Manufacturer and person authorised to prepare the relevant technical documentation
Company name: FAAC S.p.A. Soc. Unipersonale
Address: Via Calari, 10 - 40069 Zola Predosa BOLOGNA - ITALY
hereby declares that for the partly completed machinery:
Description: Automation for shutters
Model: ND2 AUTO KIT
The essential requirements of the Machinery Directive 2006/42/EC (including all
applicable amendments) have been applied and fulfilled. The relevant technical
documentation has been compiled in compliance with Annex VII B.
Furthermore, the following harmonised standards have been applied:
EN 12100:2010
EN60335-1:2012+AC:2014+A11:2014
EN60335-2-103:2015
And also undertakes to transmit, in response to a reasoned request by the national au-
thorities, relevant information on the partly completed machinery by mail or e-mail.
Finally, the manufacturer declares that the above-mentioned partly completed
machinery must not be put into service until the final machine in which it is to be
incorporated has been declared compliant with the requirements of the above-
mentioned Machinery Directive 2006/42/EC.
Bologna, Italy, 10-01-2019
27
CEO
A. Marcellan
532283 - Rev.A