Getting Started - LD Systems LAX20D Mode D'emploi

FEATURES & GettinG STARTED:
FEATURES
The LDLAX20D mixing console is designed for professional application.
It will provide the following features:
• MIC input channels with gold plated XLR and balanced LINE inputs
• Stereo input channels with balanced TRS jacks
• Ultra-low noise discrete MIC pre-amps with +48V Phantom power
• Very high headroom offering more dynamic range
• Insert on each of mono input channels
• Switchable Low-cut filter on each mono channel
• +4dBu/-10dBV selector on each mono stereo channel
• Warm, natural 4-band fixed frequency EQ on each stereo channel
• 3-band EQ with mid sweep (100Hz~8KHz) on each mono channel
• Peak LED on each channel
• Mute/ ALT 3-4, SOLO function on each channel
• 2 AUX Returns for additional functionality
• Control Room and Phone outputs
• 2-Track inputs assignable to Main Mix, Control Room/ Phones outputs
• Highly accurate 12-segment LED meters
• 24 bit digital effect processor
• Up to 100 presets
• Effect on/off by means of MUTE switch or a footswitch connected to the DFX FOOTSWITCH jack.

GETTinG STARTEd

please check the AC voltage available in your country before connecting your LD LAX20D to the AC socket.
Be sure that the main power switch is turned off before connecting the mixer to the AC socket. Also, you should
make sure that all input and output controls are turned down. This will avoid damage to your speakers and avoid
excessive noise.
Before turning on the LD LAX20D you shall connect it to a power amplifier and turn-on the mixer BEFORE the
power amplifier. once you have finished your working session you shall turn the mixer off AFTER the power
amplifier is turned off.
Before disconnecting the LD LAX20D always turn-off the power switch.
Do not use solvents to clean your LD LAX20D . A dry and clean cloth will be oK.
5