Note About Welding Bolds; General Restrictions; Start Of Operation - Adeunis RF HCA-UNITY1 Mode D'emploi

ADEUNIS RF HCA - USER GUIDE - V1.2

4.2. Note about welding bolds

During the welding process of the bold on the radiator sounds could be emitted. For pets being very sensitive to these sounds, it is recom-
mended to keep them distant from the working place.

4.3. General restrictions

It is not allowed to use Adeunis RF HCA UNITY1 on steam heating, under-floor heating or ceiling-mounted radiation radiator. The use on com-
bined valve and flap controlled radiator is not allowed too, unless the flap controlled is dismounted or inoperative. The use of HCA UNITY1 on
radiator with additional blower or heating cartridges is only admissible, if the additional electric device is in operation.

4.4. Start of operation

HCA starts operating automatically as soon as it is locked on Heat Conductor. LCD display is switching ON indicating: 888888, then starts
counting from 000000 after 10". During this first 10", the device would come back in "park mode" if removed from Heat Conductor. Beyond
this delay, the HAC definitively keeps in "operating mode". Note that the HCA can be removed from it's position till 1 hour after being started,
without triggering the tamper detection signal.
Step 1
Step 2
Step 3
Important Note : In order to preserve the battery lifetime, the display is maintained OFF during the night (each day within the time slot 10PM
to 6AM, GMT time)
10 sec
60 mn
6 hours
Page 18 of 22