Important Safety Instructions - Berner BHFB 05 12 V Manuel D'instructions

GB
Introduction
Thank you for your trust and decision of buying this advanced battery charger BHFL -
Series to charge Lead-Acid Batteries (Acid, GEL, AGM) and energy supply while servi-
cing. This digital controlled switch mode charger is the state of art of the Battery
Chargers technology. Please, follow the operating instructions to guaranty the correct
and efficient operation for long time.
Please, read the Operating Manual with attention and follow all instructions
before putting the equipment in operation.

Important safety instructions

• Save these instructions – This manual contains important safety and operating in-
structions for BHFB battery charger/maintainer
• Use BHFB Chargers only on 12 volts LEAD ACID, AGM and GELLED ELECTRO-
LYTE (GEL-CELL) batteries. Do not attempt to use on other voltages and types of
batteries (DRY CELL, NICKEL CADMIUM, NICKEL METAL HYDRIDE, etc.) com-
monly found in small home appliances. This may cause chargers and batteries to
burst, resulting in damage or injury to person and property.
• Do not expose BHFB Chargers to direct sunlight, rain or snow.
• Do not use BHFB Chargers on batteries that are in use or that are installed.
If necessary to remove batteries from the vehicle and take to a properly installed
BHFB Chargers location.
• Do not use attachments with BHFB Chargers that are not recommended. Non-
recommended attachments may result in injury, electric shock, or fire and voids
the warranty.
• To reduce risk of damage to electric plug and cord, pull by plug rather than cord
when disconnecting charger.
• An extension cord should not be used unless absolutely necessary. Use of
improper extension cord could result in a risk of fire and electric shock.
• Do not operate charger with damaged cord or plug – replace the cord or plug
immediately.
• Do not operate charger if it receives a sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified serviceman.
• Do not disassemble charger; take it to a qualified serviceman when service or
repair is required. Incorrect reassembly may result in a risk of electric shock or fire
• To prevent injury during cleaning or maintenance, disconnect all batteries and
move them to clear access to the unit. Unplug HFB Chargers from the wall outlet.
Use a slightly dampened cloth to clean the housing and lead sets. Do not use
solvents or soaps.
• Place the power cords in a location where they will not be stepped on, tripped
over, or subjected to stress or abuse of any kind.
• For fuse replacement, contact distributors for replacement. Any tampering or in
correct assembly may result in fire or electric shock and voids the warranty.
7