Reely ROAD 1:10 EP Onroad-Car Audi S5 4WD BL RtR Notice D'emploi page 47

Set alignment for the rear wheels:
The alignment for the rear wheels is set by the so-called
tie-in-block. This is a plastics part (A) screwed to the back
of the differential.
The two metal axles holding the lower transverse links
are attached to the outer holes of the toe-in block.
A toe-in block with a different distance between these
two holes can be used to adjust the toe-in of the rear
wheels.
The delivery includes a plastics part with additional toe-in blocks; see the
figure on the right.
The toe-in setting for the rear axle has little effect on driving
behaviour. Therefore, toe-in block replacement will only be
important for professional drivers.
A
47