PRO-POINT 8587974 Mode D'emploi page 2

8587974
2. Set the top guide swivel
lock into position with the swivel
knob (10). See Chain Filing
proper degree mark setting.
figure 5.
3. Insert the file into the gullet
cutter, making sure the file assembly
is positioned at 900 to the guide bar
(5). Lock the chain stop (7) to the
back of the cutter. See figure 6.
4. Set the file height by turning
depth adjustment screw (11) so that
1/5th (approx. 20%) of the file
diameter is above the top
cutter. See figure 7.
5. Adjust the stop screw
control the amount of cutter
filed. See figure 8.
6. See figure 9 for proper
cutter shape.
FILING
Correct angle on TOP PLATE
(degree of angle depends on the chain type)
Slightly protruding "hook" or point
Top of DEPTH GAUGE at correct
height below TOP PLATE
Front of DEPTH
rounded off
2
(2) and 1. File all cutter
the outside. See figure 10.
Chart for
2. File one
See
time.
3. To sharpen
of the
opposite
swivel
swivel guide (2) 1800. Reset the
angles
Set Cutter Angles section and repeat
the the filing process. See figure 12.
DEPTH
NOTE:
plate of the
sharpenings,
file the depth
(13) to
1. Remove
to be
replace
See figure
2. Set both filing angles to "00" so
that the file is 900 to the guide
See figure 14.
3. Turn
(11) and lower
the top plate of the cutter. See
figure
GAUGE
Pro Chain Sharpener
from the inside
side of the chain at a
See figure 11.
cutters on the
side of chain, unlock the
knob (10) and rotate the
°.
shown in steps 1 to 5 of the
GAUGE FILING
Every 2 to 3 chain
it is necessary to
gauges.
the round file and
with a flat depth-gauge
13.
the depth-adjusting screw
the file until it rests on
15.
to 4. Move the
the file is directly
gauge. See figure 16. Position the file
approximately
from the cutting
protect the edge from
during this step.
5. Position
the back of the
cutter position.
6. Rotate
screw (11) counter-clockwise
recommended
See the depth-gauge
Filing Chart.
NOTE: Each
depth-adjustment
file.
0.009 in. (0.23mm)
7. Always
the filing stroke is from the inside to
bar.
the outside.
one side of the chain,
swivel guide (2) 1800 reset. Reset the
same angles
the chain and repeat
process. See figure 19.
For technical questions
Vl.o
cutter backwards until
above the depth
1/16 in. (1.6mm) away
edge of the cutter to
damage
the chain stop (7) against
cutter to maintain the
See figure 17.
the depth-adjustment
to the
depth gauge setting.
on the Chain
See figure 18.
increment mark on the
screw (11) equals
of file travel.
file the depth gauges so
File all depth gauges on
then rotate the
for the opposite side of
the filing
call 1-800-665-8685