Wiring Connection - Kenwood KDC-X701 Mode D'emploi

INSTALLATION/CONNECTION

Wiring connection

IMPORTANT : We recommend installing the unit with a commercially
available custom wiring harness specific for your car and leave this job
to professionals for your safety. Consult your car audio dealer.
MIC (Microphone input
terminal) ( 17)
Antenna terminal
To front speaker (left)
To front speaker (right)
To rear speaker (left)
To rear speaker (right)
Ignition
Car fuse box
switch
Car fuse box
Black (Ground wire)
Battery
To the metallic body or chassis of the car
Output terminals
Fuse (10 A)
White
If no connections are made, do not let the wire come out from the tab.
White/Black
Gray
Brown
Gray/Black
(Mute control wire)
Green
Green/Black
Blue/White
Purple
Purple/Black (Power control wire/
Antenna control wire)
(12 V
350 mA)
Red
(Ignition wire)
Light blue/yellow
Yellow
(Steering remote control
(Battery wire)
wire)
(For
To Kenwood Marine Remote Control unit,
KCA-RC55MR (optional accessory)
USB 1 cable (DC 5 V
(For
USB 2 cable (DC 5 V
Expansion port (12 V 500 mA)
To the optional SiriusXM Vehicle Tuner
(commercially available) ( 14)
To connect the Kenwood
navigation system, refer your
navigation manual
To the power control terminal
when using the optional power
amplifier or to the antenna
control terminal in the vehicle
To the steering wheel remote
control adapter
When connecting to an external amplifier, connect its ground wire
to the car's chassis to avoid damaging the unit.
)
Part list for
installation
(A) Faceplate
1.5 A)
/ )
1.5 A)
(B) Trim plate
Auxiliary cable
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
(F) Screws (supplied for
/
)
37
ENGLISH