Troubleshooting - Kenwood KDC-X701 Mode D'emploi

DISPLAY SETTINGS
DISPLAY
COLOR Select color for ALL ZONE, ZONE 1 and ZONE 2 separately.
SELECT
1 Select a zone. (See the illustration on page 27.)
2 Select a color for the selected zone.
VARIABLE SCAN/CUSTOM R/G/B/preset colors*
Default:
To make your own color, select [CUSTOM R/G/B]. The color you have made
will be stored in [CUSTOM R/G/B].
1 Press the volume knob to enter the detailed color adjustment.
2 Press S / T to select the color (R/G/B) to adjust.
3 Turn the volume knob to adjust the level (0 to 9), then press the knob.
DIMMER Dim the illumination.
ON: Dimmer is turned on. ; OFF: Cancels.
DIMMER TIME: Set the dimmer on and off time.
1 Turn the volume knob to adjust the [ON] time, then press the knob.
2 Turn the volume knob to adjust the [OFF] time, then press the knob.
(Default: [ON]: PM6:00; [OFF]: AM6:00)
BRIGHTNESS 1 Select a zone. (See the illustration on page 27.)
2 LEVEL 0 to LEVEL 31: Select your preferred brightness level for the
selected zone.
TEXT SCROLL AUTO/ONCE: Select whether to scroll the display information automatically,
or scroll only once. ; OFF: Cancels.
* Preset colors: RED1/RED2/RED3/PURPLE1/PURPLE2/PURPLE3/PURPLE4/BLUE1/
BLUE2/BLUE3/SKYBLUE1/SKYBLUE2/LIGHTBLUE/AQUA1/AQUA2/GREEN1/
GREEN2/GREEN3/YELLOWGREEN1/YELLOWGREEN2/YELLOW/ORANGE1/ORANGE2/
ORANGERED
28
ENGLISH
Default: XX
/ / /
: VARIABLE SCAN
: CUSTOM R/G/B (R = 9/G = 9/B = 9)

TROUBLESHOOTING

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN POWER ON" appears.
"PROTECTING SEND TO
SERVICE" appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all.
(For )
"SET ERROR"/
"DELETE ERROR"
• Radio reception is poor.
• Static noise while listening
to the radio.
Disc cannot be ejected.
Noise is generated.
Tracks do not play back as
you intended them to play.
"READING" keeps flashing.
Elapsed playing time is not
correct.
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the
terminals of the speaker wires are insulated properly.
Turn the power on again.
Send the unit to the nearest service center.
Clean the connectors. ( 31)
Reset the unit. ( 3)
Setting/deleting the remote control ID is
unsuccessful. Turn the power off, then turn on the
power and perform the operation again.( 5)
Connect the antenna firmly.
Press and hold M to forcibly eject the disc. Be careful
not to drop the disc when it is ejected. If this does not
solve the problem, reset the unit. ( 3)
Skip to another track or change the disc.
Playback order is determined when files are
recorded.
Do not use too many hierarchical levels or folders.
This is caused by how the tracks are recorded.