Kenwood KDC-X701 Mode D'emploi page 22

BLUETOOTH®
Connect with a remote device by One-touch (NFC)
Near Field Communication (NFC) enables short-range wireless
communication between the unit and remote devices such as
smartphones.
By holding an NFC-compatible remote device near to the N-Mark
on the unit (right side of the panel), the unit and remote device
proceed to complete pairing and established the BLUETOOTH
connection automatically.
1
Activate the NFC function on the remote device.
Refer to the instruction manual of the remote device for more
information.
2
Hold the remote device near to the N-Mark on the unit (right
side of the panel).
The device vibrates when pairing is completed.
• Depending on the type of remote device used, the strength of
the NFC signal may vary. For a stronger NFC signal, user must
understand the position of the remote device's NFC antenna and
hence tap the NFC antenna with the NFC logo.
• To disconnect, hold the remote device near to the N-Mark on the
unit again.
• This unit only can recognize and connect to one NFC-compatible
device at a time.
18
ENGLISH
BLUETOOTH — Mobile phone
Receive a call
When there is an incoming call:
• ZONE 2 illuminates in green color and flashes.
• The unit answers the call automatically if [AUTO ANSWER] is set to a selected
time. ( 19)
During a call:
• ZONE 1 illuminates according to the settings made for [DISPLAY] ( 28) and
ZONE 2 illuminates in green color.
• If you turn off the unit or detach the faceplate, the Bluetooth connection is
disconnected.
The following operations may differ or not available depending on the
connected phone.
To On the faceplate
First incoming call...
Answer a call
Press
knob or one of the number
buttons (1 to 6).
Reject a call
Press
End a call
Press
On the remote control
or the volume Press .
Press
.
Press
.
.
.