Teletask TDS13644 Manuel Technique page 69

Leading edge: the cutting of the phase will occure at the begining of each phase.
Trailing edge: the cutting of the phase will occure at the end of each phase.
This option can only be set manually when the lamp type has been set to "Others".
Curve type
The curve at which the dimming will occur.
Linear: The voltage will increase linear for each dimming step.
Fast: The voltage will increase at a faster rate then the other curves at the beginning of the dimming curve.
Medium: The voltage will increase at a medium rate at the beginning of the dimming curve.
Slow: The voltage will increase very slow at the beginning of the dimming curve.
Minimum DIM level
Specifies the initial start dim percentage. the minimum dim level will recalculate the actual dimmer values
(percentage range beween 0 and 40).
23/1/2018
TELETASK ne peut pas être tenu responsable des potentielles erreurs dans les fiches techniques et dans la documentation technique.
Des changements dans les caractéristiques des produits peuvent être effectués à tout moment, sans préavis. ©, TELETASK, GENT
Page 68