Nyne NH-6000 Manuel Utilisateur page 23

•
Check whether the video is being
played on the screen of your iPod/
iPhone/iPad. If so, press and hold
on the remote control to
switch to video play on the TV.
•
Adjust the aspect ratio on the TV.
Why is there no response when I use the remote control to
operate the device?
•
Move closer to the device and try
again.
•
Aim the remote control directly at
the front of the device.
•
The battery may be used up.
Replace the battery with correct
polarity.
Why is my iPod/iPhone/iPad not charged after docking?
•
Check whether you have
connected the power cable to
both the device and wall socket
securely.
•
Check whether you have docked
your iPod/iPhone/iPad securely.
•
Check whether you have turned
the
the back of the device to the
position.
•
The device does not support iPod/
iPhone/iPad charging in standby
mode. Press
control to turn on the device.
Why is it that I cannot find "NH-6000" on the device
already paired with NH-6000?
•
Check whether you have turned on
NH-6000.
•
Make sure that you have enabled
the Bluetooth function on the
device paired with NH-6000.
•
You may have failed to pair the
device with NH-6000. Repeat the
pairing procedures.
NYNE NH-6000_User Manual_A5.indb 23
switch on
on the remote
•
Check whether NH-6000 is
connected wirelessly with another
paired device. NH-6000 only
supports one Bluetooth connection
at a time.
Why is it that my alarm timer does not ring at the preset
time?
•
If you have selected dock as the
alarm source, make sure that the
playlist in your iPod/iPhone/iPad is
not empty.
•
Check whether you have set the
volume level of the alarm timer to
the minimum level.
Why is my clock, sleep timer or alarm timer setting
erased?
•
You may have encountered power
outage or unplugged the power
cord. Power on the device and set
the clock, sleep timer or alarm timer
again.
EN 23
5/17/2012 9:30:36 PM