Set Clock - Nyne NH-6000 Manuel Utilisateur

2
Press on the remote control.
The LED screen lights up with clock
+
display (if set).
The indicator of the last selected
+
audio source lights up.
If the alarm timer is active, the
+
indicator also lights up.
To switch the device to standby mode:
• Press on the remote control
again.

Set clock

1
When the device is turned on,
press
control once (or tap
top panel once).
"TIME" is displayed on the LED
+
screen.
2
Press
control to confirm.
The hour digits start to flash.
+
3
Press
control (or tap
panel) repeatedly to adjust the
hour, and then press
confirm.
The minute digits start to flash.
+
4
Press
control (or tap
panel) repeatedly to adjust the
minute, and then press
confirm the set clock.
To activate clock display in standby mode:
• When the device is turned on,
press
control repeatedly until "ON" is
displayed on the LED screen.
NYNE NH-6000_User Manual_A5.indb 13
on the remote
on the
on the remote
on the remote
on the top
to
on the remote
on the top
to
on the remote
The clock display remains on the
+
LED screen when the device is
switched to standby mode.
To deactivate clock display in standby mode:
• When the device is turned on,
press
control repeatedly until "OFF" is
displayed on the LED screen.
The LED screen dims out when
+
the device is switched to standby
mode.
Tips:
•
The device only supports the 24-
hour clock system.
•
During clock setting, if there is no
operation within six seconds, the
current settings will be cancelled.
on the remote
EN 13
5/17/2012 9:30:32 PM