Replacing The Belt - CERTIFIED 060-0581-2 Guide D'utilisation

19
model no. 060-0581-2
7. Place the tensioner back into position.
Rotate the paddles to ensure that the belt
and paddles move freely, then reinstall
the cover by securing it with the seven (7)
screws (Figs. 15 & 16).
WARNING! Do not power the unit until the
cover guard is securely in place to prevent
damage or injury.

Replacing the Belt

WARNING! Disconnect the power from the electric snow shovel before performing these tasks.
1. Disassemble the left side cover by
removing the seven (7) screws (Fig. 10).
2. Remove the tensioner (Fig. 17).
3. Unscrew the three (3) screws from the big
pulley plate and the four (4) screws from
the small pulley plate (Fig.17).
4. Replace the worn belt with a new belt.
5. Screw the big and small pulley plates back
into position, then reinstall the tensioner.
6. Place the left side cover back into position
and refasten the seven (7) screws.
I contact us: 1-844-428-7277
Fig. 15
Tensioner
Big pulley plate
Fig. 16
Fig. 17
Small pulley plate
Belt
Tensioner
Big pulley plate