Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
R
E
S
T
O
R
I
N
G
F
A
C
T
O
R
E
S
T
O
R
I
N
G
F
A
C
T
O
The siren parameters can be reset and the memory deleted through the following procedure:
a. Switch off the Tamper function on the control unit. The siren will beep to indicate that the Tamper switch is off.
b. Remove the siren from the list of devices on the control unit (see the instruction manual of the control unit).
c.
Remove the screw from the bottom of the top cover and remove the top cover.
d. Move the power switch to the OFF position and press Tamper a couple of times to fully discharge the power from the
siren.
e. Set DIP Switch 6 to the ON position and the power switch to the ON position. The siren will emit a short beep to
confirm the reset.
f.
Set the DIP Switch to the OFF position
g. Reposition the top cover by latching it to the top of the base. Press the bottom of the top cover onto the base and
tighten the screw on the bottom.
h. The siren can now be learnt again with the factory settings restored.
Hereby, URMET S.p.A. declares that the radio equipment type: OUTDOOR SIREN WITH FLASHER 1051/405 is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.urmet.com.
TO ACCESS THE PRODUCT TECHNICAL SHEET AND DOWNLOAD THE COMPLETE MANUAL CLICK ON
THE LINK
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical and
electronic equipment (WEEE).
The symbol of the crossed-out wheeled bin on the product or on its packaging indicates that this product must not be
disposed of with your other household waste.
Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the
recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of
disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health and the
environment.
For more information about where you can drop off your waste equipment for recycling, please contact your local city office, your
household waste disposal service or the shop where you purchased the product.
DS1051-034
The tamper switch pin must be pressed completely
against the wall.
R
Y
D
E
F
A
U
L
T
S
E
T
T
I
N
R
Y
D
E
F
A
U
L
T
S
E
T
T
I
N
SIMPLIFIED EU DECLARATION OF CONFORMITY
G
S
G
S
7
Publicité
Table des Matières
