JK-Products Ergoline EVOLUTION 660 TURBO POWER Instructions D'utilisation page 49

Relamping / maintencance instructions
It is imperative that you, the owner and/or operator, check all compon-
ents for any signs of wear which may occur through normal use.
– Observe the cleaning and maintenance schedule specified in the
maintenance table on Page 42 to 47.
– Only replace UV low-pressure lamps with the original lamp type or with
compatible lamps.
– Only replace UV high-pressure lamps with the original lamp type or with
compatible lamps.
Should you require any assistance or need additional information, please
call Global Service Division at 1-800-445-0624, Monday through Friday
7:00 a.m. - 7:00 p.m. (CST)
CAUTION – Damage due to improper maintenance!
Improper maintenance can cause the device to be damaged
or to become unusable.
– Always comply with the specified maintenance intervals.
– Follow the cleaning instructions.
– If the maintenance intervals for the UV lamps are exceeded or incom-
patible UV lamps are installed, the share of harmful UVB radiation may
increase. Sunburn and other skin damage may result.
48
Danger of burns from hot lamps and device parts
WARNING!
If the tanning device was operated before being swit-
ched off and opened, lamps and housing parts may be
hot.
– Before replacing lamps or other spare parts, wait until
lamps and metal parts of the device have cooled
down sufficiently.
Danger of pinching!
When opening and closing the tray, panels and covers,
you can pinch your fingers.