Bartscher 191004 Mode D'emploi page 35

Keeping the water hot
•
After boiling, you can keep the water hot with the keep-warm function. Set the
keep-warm switch at "I". The blue control light will turn on. It will turn off only
when you set the switch at "O".
Adding water
WARNING! Risk of injury!
Hot steam may release when you lift the lid to fill in the hot water container.
It may cause burns to your hands, arms and face. First, leave the appliance
for a few minutes to cool down and only then carefully lift the lid.
•
When there is only little water left in the container you can add more fresh water
after the appliance has cooled down. Lift the lid and add fresh water to the
container through the holes in the cover.
NOTE!
The appliance is equipped with over-heating protection that will be initiated
when there is no water in the container (or when there is only little water left).
When the protection has been initiated unplug the appliance and leave it for a
few minutes to cool down before refilling.
Drawing the water
•
Place a suitable container (cup, glass, teapot,
etc.) under the tap. Draw the water from the
container, carefully turn the faucet forward.
•
After you have drawn the required amount of
water turn the faucet again to the right.
Turning the appliance off
•
Once the keeping-warm or boiling has finished turn off the appliance by setting
the keep-up warm switch at "O". Disconnect the appliance from the power
supply (unplug!).
- 34 -