Makita GA4541C Manuel D'instruction page 8

For tool with clamp lever type wheel
guard
► 1. Wheel guard 2. Bearing box 3. Screw 4. Lever
Pull the lever in the direction of the arrow after loosen-
ing the screw. Mount the wheel guard with the protru-
sions on the wheel guard band aligned with the notches
on the bearing box. Then rotate the wheel guard around
180°.
1
► 1. Screw 2. Lever
Tighten the wheel guard with fastening the screw after
pulling lever in the direction of the arrow. The setting
angle of the wheel guard can be adjusted with the lever.
To remove wheel guard, follow the installation proce-
dure in reverse.
1
2
3
4
2
8 ENGLISH
Installing or removing depressed
center wheel or multi-disc (optional
accessory)
WARNING:
• When using a depressed center wheel or multi-
disc, the wheel guard must be fitted on the tool
so that the closed side of the guard always
points toward the operator.
► 1. Lock nut 2. Depressed center wheel 3. Inner
flange
Mount the inner flange onto the spindle. Fit the wheel/
disc on the inner flange and screw the lock nut onto the
spindle.
1
2
► 1. Lock nut wrench 2. Shaft lock
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
To remove the wheel, follow the installation procedure
in reverse.
1
2
3