Progress Lighting 5641 Instructions De Montage Et D'installation

*PROGRESS
LIGHTING
WARNING - If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full
compliance with N.E.C. requirements.
WARNING - To comply with the National Electric Code and Underwriters Laboratories requirenents, the edge of the wall
plate coming in contact with the mounting surface, must be sealed with a latex waterproof caulking to prevent water from
entering the oulet box.
6
2
WH TE SUPPLY WHITE OR IDENTIFIED
WIRE FIXTURE WIRE
UL LISTED
WIRENUTS
BLACK SUPPLY PLAIN OR BLACK
WIRE FIXTURE WIRE
BARE, OR GREEN BARE, OR GREEN
GROUND WIRE FIXTURE GROUND
FROM SUPPLY WIRE
OR
BARE, OR GREEN
GREEN
SCREW
GROUND WIRE
FROM SUPPLY
Assembly
CAUTION: Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation.
5641 , 5643, 5674, 5712
If there are any questions, contact a Qualified Electrical Contractor.
1
5
3
4
GROUND
& Installation
7
8
9
CAUTION: All glass ISfragile, use care when handling lamp(s) or
other glass components
I . Fasten Mounting Plate (I) to Outlet Box (2) with Mounting Screws
(3) from Outlet Box (2) (NOT FURNISHED). Thread Green Ground
Screw (4) into Mounting Plate (1 )
2. Connect Fixture Wires (5) to Supply Wires (6) as shown on wring
diagram.
3 Slip Fixture Assembly (7) over Mounting Plate (I) and secure In
place with Set Screw (8). Use Wrench (9) to tighten Set Screw (8)
4. Install lamp (NOT FURNISHED)
PAGE 1
SPEC.NO.
Instructions
DOWN
HACIA ABAJO
VERS LE BAS
023402 04/19/18