Télécharger Imprimer la page
OGRESS
LIGHTING
WARNING
- If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full
compliance
with N.E.C. requirements.
WARNING - To comply With the National Electric Code and Underwriters Laboratones requirements, the edge of the wall
plate corning in contact With the mounting surface must be sealed with a latex waterproof caulking to prevent water from
entering the outlet box
WARNING
- This product contains
reproductive harm Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product
CAUTION
- All glass is fragile, use care when handling Glass component(s) and or Lamp(s)
WHITE SUPPLY
WHITE OR IDENTIFIED
WIRE
FIXTURE
WIRE
UL LISTED
WIRE NUTS
BLACK SUPPLY
PLAIN OR BLACK
WIRE
FIXTURE
WIRE
BARE. OR GREEN
BARE, OR GREEN
GROUND
WIRE
FIXTURE
GROUND
FROM SUPPLY
WIRE
5
6
4
3
2
1
- Fasten Mounting Plate (2) to Outlet Box (1 ) with Mounting Screws (3) from Outlet Box (1 ). Thread Machine Screws (4)
into Mounting Plate (2)
2.- Connect Supply Wres (6) to Fixture Wires (5) as shown on Wiring Diagram.
Slip Fixture Housing (7) over Machine Screws (4) and secure with Capnuts (8). (SEE WARNING ABOVE).
3
4 - Attach Fixture Roof (9) to Fixture Housing (7) by squeezing Fixture Housing (7) as shown. Position Holes (12) on sides
of Fixture Housing (7) over corresponding
(11) Will snap Into position
5 - Before snapping Fixture Roof (9) shut install Plastic Panels (10). (TEXTURED SIDE OUT)
6 - Install lamp (14)
WARNING
- FIRE
HAZARD
APPEARS
TO COME
IN CONTACT
7 - Snap Fixture Roof (9) closed as shown
8 - Thread Fixture Tail (13) into Fixture Housing (7).
Assembly
CAUTION:
Read instructions
arcuit
5656,
If there are any questions,
chemicals
known to the State of California
9
7
8
Pins (11) on underside of Fixture Roof (9). Release Fixture Housing (7) - Pins
. DO
NOT
ALLOW
LAMP
WITH FIXTURE
& Installation
carefully and turn electricity off at man
breaker
panel before beginning
5657
contact a Qualified
to cause cancer,
14
10
11
9
12
7
TO TOUCH
ANY
PORTION
INTERIOR
OR PANELS,
ADJUST
PAGE
1 of
2
Instructions
installation.
Electrical Contractor.
birth defects and lor other
1, 3, 6, & 14
(NOT FURNISHED)
(NO INCLUIDA)
(NON FOURNIE)
9
7
13
13
OF THIS
FIXTURE.
IF LAMP
SOCKET
TO MOVE LAMP.
SPEC
NO
023707
5656
5657
08-17-09
loading

Sommaire des Matières pour Progress Lighting 5656

  • Page 1 Read instructions carefully and turn electricity off at man arcuit breaker panel before beginning installation. 5656, 5657 WARNING - If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full compliance with N.E.C. requirements.
  • Page 2 Instrucciones de ensamblaje e instalaci6n Precauciön: Lea cuidadosamente las instrucciones y desconecte Ia electricidad del cortacircuitos principal antes de iniciar' Ia instalacion. ADVERTENCIA - Si usa algün dispositivo especial de control con este aparato de luz, Siga las instrucc•ones cuidadosamente para asegurar la completa conformdad con los requisitos N.E.C.

Ce manuel est également adapté pour:

5657