ECG FS 91 T Mode D'emploi page 26

At factory setting there is no set timer period. You can set period 1h, 2h, 4h, 8h by pressing this button. The set
period is indicated on the display. After the set time passes the appliance goes into standby mode.
MODE 5
When you press the MODE button, you switch operation modes in following order: normal -> summer -> night
-> normal ->etc. LED indicates the current mode.
NORMAL: the device runs according to current setting and constant fan rotations.
SUMMER: the motor will work automatically in alternating cycles of high-medium-low rotations as shown on
the following diagram.
GB
NIGHT: Press MODE button to light up the relevant LED for night mode.
In this mode, the fan switches on and off in the set speed and saves energy during the night.
1. If upon starting the Sleep mode the fan is set to high speed, the fan runs fi rst 5 hours at high speed and
then for additional 5 hours switches to medium speed, then for further 5 hours switches to low speed. The
entire cycle repeats itself until the preset time is completed or until the appliance is switched off .
2. If upon starting the Sleep mode the fan is set to medium speed, the fan runs fi rst 5 hours at medium
speed and then for additional 5 hours switches to low speed until the preset time is completed or until the
appliance is switched off .
3. If the appliance is set to low speed, the fan runs at low speed until the preset time is completed or until
the appliance is switched off .
SWING 4
Press the button SWING once. The fan starts to oscillate in the horizontal plane and the LED indicator lights up.
Press again to switch off the oscillation.
Note: Using tabs protruding on the front cover you can mechanically set the vertical incline of the inner slats.
OFF 3
Press OFF button to turn off the appliance and the fan stops.
When you are not using the device, always unplug the power cord from the electrical outlet.
26
High
Medium
Low
High
Medium
Low
NATURAL mode at medium rotations
High
Medium
Low
NATURAL mode at high rotations
NATURAL mode at low rotations