Using Your Microphone; Connecting The Microphone - AKG Acoustics CCS Série Mode D'emploi

Please make sure that the piece of equipment
your microphone will be connected to fulfills the
safety regulations in force in your country and is
fitted with a ground lead.
D 11, D 22, D 77 S/XLR, D 88 S/XLR
Use the supplied balanced cable to connect the
microphone to the desired XLR input.
D 77 S/Jack, D 88 S/Jack
Use the supplied unbalanced cable to connect
the microphone to the desired 1/4" input jack.
Please note that unbalanced cables may pick up
interference from stray magnetic fields near power
or lighting cables, electric motors, etc. like an
antenna. This may cause hum or similar noise when
you use a cable that is longer than 16 feet (5 m).
1. To switch the microphone on, slide the on/off
switch toward the front grill ("ON" position).
2. To switch the microphone off, slide the on/off
switch toward the microphone cable ("OFF"
position).
To prevent unwanted bursts of noise, be sure
to switch the microphone off before connect-
ing or disconnecting the microphone cable.

2 Using Your Microphone

2.1 Precaution
2.2 Connecting
the Microphone
Refer to fig. 1.
Refer to fig. 2.
2.3 Switching
the Microphone
on/off (D 77 S,
D 88 S)
Refer to fig. 3.
Note:
11