PRO-POINT 8587966 Mode D'emploi page 2

8587966
2. Set the top swivel (2) to the
correct angle mark. See the Chain
Filing Chart or the chain
manufacturer's instructions
correct degree mark. See figure
a. Lock into position
swivel knob (10). See figure 8.
3. Insert the file into the cutter,
making sure the file assembly
positioned at 900 to the T-bars
See figure 9.
4. Place the back of the cutter
against the chain stop (7). See
figure 10.
5. Set the file
height by turning
the depth
adjustment screw
(12) so that 1/5th of the file diameter
above the top plate of the cutter.
figure 11.
6. Adjust the stop
screw (13) to control
the amount of the
cutter to be filed. See
figure 12.
2
Deluxe Bar-Mount
FILING
Correct angle on TOP PLATE
(degree of angle depends on the chain type)
for the
7.
with the
I. File all cutters
the outside.
at a time. See figure 13.
is
NOTE:
(5).
reduced
against
2. To sharpen
opposite
swivel
swivel
on the opposite
3. Reset the angles
to 6 of the Operation
is
and repeat the filing process. See
See
figure
HINT: Oil the slide rod at the guide
swivel
guide
o o
Chainsaw Sharpener
Slightly protruding "hook" or point
Top of DEPTH GAUGE at correct
height below TOP PLATE
Front of DEPTH GAUGE
rounded off
from the inside
File one side of the
File performance is greatly
if you file from the outside
the chrome plating.
cutters on the
side of the chain, unlock the
knob (10) and rotate the
guide (2) to the similar setting
side. See figure 14.
shown in steps
instructions
15.
for better movement of the
assembly.
DEPTH GAUGE
NOTE: Every
sharpenings,
file the depth
1. Remove
replace the handle
Reinsert into
to
secure. See figure 16.
chain
2. Set both
filing angles
that the file
the guide bar. See
figure 17.
3. Turn the adjusting
lower file until
plate of the cutter.
4. Move the
the file is directly
1
gauge. Position
-
1/16 in. (1.6mm) away from the
cutting edge of the cutter so as to
protect the edge from
during this step.
5. Rest the chain stop (7) on the top
plate of the cutter
operation.
For technical questions
Vl.o
FILING
2 to 3 chain
it is necessary to
gauges.
the round file and
onto the flat file.
the file holder and
of the
to 00 so
is 900 to
GUIDE
screw (12) and
it rests on the top
See figure 18.
cutter backwards until
above the depth
the file approximately
damage
See figure 19.
during the filing
See figure 20.
call 1-800-665-8685