Hisense HBE3401NAS Mode D'installation page 8

1
2
Three-Wire Cord Connection
! WARNING!
The neutral wire of the power cord must be connected
the center of the terminal
and the lower right terminals
B
c
Remove the 3 screws lower the terminal on the terminal block. Do not loosen the upper screws.
Install the three-wire cord kit and strain relief in the hole in the connection
Connect the center (white/neutral)
Connect the red and black
Push the cord upward (to relieve strain), while tightening
Securely tighten each screw (35 to 50 in-lbs)
Prepare the conduit
as shown
Install
plate as shown in B.
Insert the strain relief into the conduit
1/8'l). Then thread the conduit cord through the
body (2) of the strain relief and fasten the ring
(1). Reinstall the connection
and screw up.
block. The power leads must be connected
of the terminal block.
1
1
2.
3.
2
4.
3
5.
4
5
A.
B.
c.
wire lead to the center terminal.
leads to the outside terminals.
cord (insulation stripped)
in A.
the conduit cord into the connection
plate into possition
to the neutral terminal
to the lower left
Live 1
Ground strap
Neutral terminal
Live 2
Ground plate
Black
White
Red
plate.
the strain relief clamp.
hole (1
located in