Rating Plate - Hisense Hbe3401Nas Mode D'installation

Minimum dimensions
30"
15"
Cabinet storage space above the cooktop
reaching over hot surface elements.
the risk can be reduced by installing an appliance
the cabinets. Cabinets installed above the cooktop
Rating plate
between cooktop, walls and above the cooktop
6"
should be avoided to reduce the risk of burns or fire when
If cabinet storage space is to be provided above the cooktop,
hood that projects at least 5" beyond the front of
must be no deeper than 16"
Provide adequate clearances
•
range and adjacent combustible
These dimensions must
use of your appliance.
Make sure the wall covering,
flooring and cabinets around the range can
withstand the heat (up to 2000F (9000))
generated by the range.
Allow 30 ' minimum clearance
•
surface units and bottom of an unprotected
wood or metal cabinet,
minimum when the bottom
metal cabinets is protected
1/4" thick flame retardant
covered with not less than
metal, (0,015") thick stainless steel, 0,024 '
aluminium or 0,0201' copper.
This appliance has been approved for O '
•
spacing to adjacent surfaces above the
cooktop. However, a 6" minimum spacing
to surfaces less than 15"
cooktop and adjacent cabinet is
recomended to reduce steam, grease
platter, and heat exposure.
Install with zero clearance
back.
NOTE! The cooktop must be at or above the
counter.
The rating plate indicating the basic information
about the appliance is located on the oven
frame and it is visible when
opened.
between the
surfaces.
be met for the safe
countertop,
between
or allow a 24 '
of wood or
by no less than
millboard
No 28MSG sheet
above the
on sides and
the oven door is