Electrical - Hisense Hbe3401Nas Mode D'installation

Electrical

installation
O
O
Range rating, watts
120/240 volts 120/208
3-wire 3-wire
1 1900 - 14200 8900 - 10800
For power cord installation
Assemble the strain relief in the connection
relief and tighten the clamp screws.
•O
NOTE! The power cord must always be installed with strain relief mounted
NOTE! Terminals on the power cord must be closed-loop
For conduit installation
o
00
1%"
1%"
Specified rating
power-supply-cord
kit, amperes
volts 40 or 50 A
plate hole (1 3/8"). Insert the power cord through the strain
1
2
3
Power cord and conduit
On the back side of the appliance
metal cover by removing screws using a
screwdriver. Do not discard
- INFORMATION!
NOTE! Power cord and
relief are not included in the appliance.
must be purchased separately.
of Diameter (inches)
connection opening
Power cord
1 Conduit connection plate
2. Power cord
3. Strain relief
into the connection
or open-end spade lugs.
Remove the conduit connection
removing two screws and rotating it, as shown
below. The conduit hole (1 1/811)must be used.
Tighten both screws back.
installation
remove the
these screws.
conduit with strain
It
of the range
Conduit
plate.
plate by