Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9
CLEANING THE AGITATOR
Regularly clean the agitator to maintain maximum cleaning performance.
1. Turn the Robot off.
2. Turn the Robot over. [Fig. 21]
3. Press the clips on the sole plate, remove the cap and then remove the agitator. Remove hair and
lint, etc. by hand or with a brush.
CLEANING THE EDGE SIDE BRUSHES
The edge cleaning brushes can be easily worn from heavy use so you should check them regularly to
monitor their condition.
1. Switch the Robot off and turn it over.
Fig. 21
2. Unclip the two edge side brushes.
3. Use a pair of scissors to remove any trapped hair or debris.
CLEANING THE DRIVE WHEELS
1. Switch the Robot off and turn it over.
2. Remove any dirt or hair trapped in the wheels.
3. Clean the wheels with a dry cloth. [Fig. 22]
IMPORTANT NOTICE
Only use approved replacement parts for your Robot.
Using parts not validated by Hoover are dangerous and will invalidate your guarantee.
If the Robot will not to be used for several months, please remove the batteries and store in cool a dry
location.
Fig. 22
IMPORTANT: Always make sure your device is switched off before changing.
Always use two hands to lift and carry, and ensure the robot is held level. [Fig. 23]
9JGP NKHVKPI VJG TQDQV ENGCPGT GPUWTG [QW FQ PQV ITKR VJG NVGT EQORCTVOGPV VQ CXQKF CEEKFGPVCN
opening. [Fig. 24]
You should avoid using your robot cleaner in direct sunlight or on dark polished surfaces as these
conditions will adversely affect the behaviour of your robot. [Fig. 25]
TROUBLESHOOTING
Fig. 23
The following is a list of commonly encountered problems and solutions.
If any of these problems persist contact your local Hoover representative.
The Robot does not work
Cleaning power is weak
Fig. 24
The Robot is very noisy
while cleaning
The Robot does not
automatically charge
Robot is trapped
Fig. 25
IMPORTANT INFORMATION
Hoover Spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local Hoover dealer
or direct from Hoover. When ordering parts always quote your model number.
Quality
*QQXGT U HCEVQTKGU JCXG DGGP KPFGRGPFGPVN[ CUUGUUGF HQT SWCNKV[ 1WT RTQFWEVU CTG OCFG WUKPI C
quality system which meets the requirements of ISO 9001.
Your Guarantee
6JG IWCTCPVGG EQPFKVKQPU HQT VJKU CRRNKCPEG CTG CU FG PGF D[ QWT TGRTGUGPVCVKXG KP VJG EQWPVT[ KP YJKEJ
it is sold. Details regarding these conditions can be obtained from the dealer from whom the appliance
was purchased. The bill of sale or receipt must be produced when making any claim under the terms of
this guarantee.
Subject to change without notice.
•
Robot requires attention.
•
Check that the Robot is switched on.
•
Check that the dust container, filter are clean.
•
Check if the Robot needs to be charged.
•
Turn power off and empty dust container.
•
Check and clean the filter and motor.
•
Check and clean the Floor Brushes.
•
Check and clean the sensors.
•
Check and clean the drive wheels.
•
Clean the dust container and filter.
•
Check the brushes and drive wheels for dirt and debris.
•
Make sure there are no barriers between the Robot and the
charger station.
•
The Robot will attempt to free itself but in some cases assist
the Robot manually.
GB
Publicité
Table des Matières
